They are suitable for transferring liquids containing impurities up to 3 mm in size. The hydraulic components - impeller, scroll and pump body made of PBT - allow them to be used with emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The liquid temperature must not exceed 90°C.

They are commonly used on

• machine tools (milling machines-turning centres)
• glass processing machines
• printing machines
• filtration systems
• air conditioning and conditioning systems

They should normally be installed on a tank with a capacity proportionate to the flow rate, approximately 4-5 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is advisable to construct the tank in compartments, to allow the sludge to settle before it is pumped out of the pump.

SOME MODELS MAY BE AVAILABLE IN 2-3 WEEKS