Bridge saw Battipav PRIME 150S

STRUCTURE

In extruded aluminum for maximum strength and lightness.

BEAM

made of extruded aluminum with high torsion resistance. Equipped with interchangeable stainless steel bearing guides.

MILLIMETER SCALE

for the rapid execution of series cuts.

GONIOMETRIC TEAM

professional standard and millimeter stop.

WORKTOP EXTENSION - (OPTIONAL)

in galvanized steel with the possibility to be mounted on both sides of the machine; it allows the cutting of large formats.

SLIDING TROLLEY

The motor unit carriage slides on the beam by means of eight ball bearings, four of which always work perpendicular to the beam.

45° POSITION

Position for 45° cutting.

The wiring of the wires is integrated inside the beam to prevent them from interfering in the cutting zone.

3 Hp / 2,2 Kw motor with thermal and amperometric protection.

CUTTING DEPTH ADJUSTMENT

The cutting depth is adjusted by locking the tilting of the motor unit.

A convenient centimeter scale directly indicates the depth of cut.

CONTROL PANEL

The immediately accessible control panel includes:

• Safety switch with minimum voltage coil.
• Current circuit breaker with manual reset in case of disc locking.
• Red light for network presence signal.
• Green light for signaling machine operation.
• Laser for maximum cutting precision (optional in the standard version).
• Industrial type plug.

WORKTOP

in large galvanized steel (620 mm).

ABS tank resistant to impact and wear.

• Easy to clean.
• Designed to separate cutting debris from the water recovery area.

Pump for water recirculation.